LIMITED SEATS AVAILABLE!

FTIR Training for Natural Gas Compressor Engines

Sponsored by the West Virginia Department of Environmental Protection

October 25-26, 2016

 

COURSE LOCATION

West Virginia Department of Environmental Protection
601 57TH Street
Charleston, WV  25304
Dolly Sods Conference Room (Room 1125)

INSTRUCTOR

Robert Bosco, Principle Applications Engineer
Process & Environmental Analysis Solutions
MKS Instruments, Inc.

AGENDA (Draft agenda will be available on APTI-Learn in the near future)

 October 25, 2016 – 8:30 AM – 4:00 PM

October 26, 2016 – 8:30 AM – 4:00 PM

COURSE DESCRIPTION

FTIR spectrometers can be used in many different types of emissions applications.  With the ability to measure hundreds of compounds, widespread use has been realized in CEM, stack testing, and engine certification markets.  Each market has its own analytical challenges, such as the level of interferences present, that can have an effect on detection limits and quantification.  With decades experience in these areas, MKS has worked diligently to provide fully developed “recipes” specific for the type of source being tested.  In doing so, the data quality from an MKS FTIR user employing these “recipes” is of the highest quality.  Because an FTIR collects a full spectrum it is in a unique position whereby the actual method used can be evaluated post data collection and updated if a gas component was missing during the original data collection. This type of “reprocessing” of the FTIR data will be shown and the MKS tools that can be used to evaluate the original method or recipe.

An overview of ASTM Method D6348 will be given and the steps associated with running a complete method will be presented.   The ASTM method has a number of QA/QC calculations that are required to determine detection limits and spectral “goodness-of-fit” which will be presented and discussed.

The course will include an overview of the basic checks that should be done for any FTIR system.  This includes, but is not limited to, spectral resolution, detector linearity, and signal-to-noise ratio.

COURSE GOALS

The class is focused around using the ASTM D6348 method which is an approved methodology for many emissions compliance measurements.
By the end of the course, the student should be able to:

    --  Understand how to ensure the FTIR is working properly
    --  Understand what is necessary to perform a field test using extractive FTIR
    --  Understand the QA/QC performance parameters of ASTM D6348
    --  Run a field test using ASTM D6348 methodology
    --  Know and understand what to look for when reviewing FTIR data results

WHAT TO BRING:

Students should bring the following equipment and materials:

    --  Laptop Computer
    --  Flash Drive (Minimum 4 GB)
    --  Notebook
    --  Pens and Pencils

 

REGISTRATION

Please register on-line at www.APTI-learn.net

Registration Deadline Date: October 21, 2016

There is no fee to attend this course.

TRAVEL SUPPORT REQUESTS and AREA HOTEL INFORMATION

If you are interested in attending this course and would like to request travel support, the request must come from your state Air Director directly to MARAMA’s Executive Director, Susan Wierman, with a copy to MARAMA’s Training Coordinators, Jackie Burkhardt and Sue Dilli (This email address is being protected from spambots. You need JavaScript enabled to view it.). It is essential to include a list of what type of support is needed, an estimate of costs, and the reason for the support. MARAMA will consider the request as consistent with MARAMA’s Travel Policy as outlined on our website marama.org. Participants are responsible for all incidentals. 

 

All attendees are responsible for booking their own reservations.  There are several hotels nearby to choose from (two are listed below).  Please note that any staff member, who MARAMA supports for this meeting, should stay at a hotel which offers the government per diem rate, not to exceed $107.00 plus tax, in order for MARAMA to provide reimbursement.  When booking your reservation, please indicate that you are a government employee in order to get the government per diem rate.  You will need to show your government ID upon check-in. If you should have any questions or concerns regarding this, please contact Jackie Burkhardt or Sue Dilli (This email address is being protected from spambots. You need JavaScript enabled to view it.)

 

Country Inn & Suites
(304) 925-4300
www.countryinns.com

Holiday Inn Express
(304) 925-1171
www.ihg.com

Days Inn Charleston East
(304) 925-1010
www.daysinn.com